12KW EMP Shield Complete Offgrid Solar Kit - 15kWh Lithium Battery + 15K Sol-Ark Inverter +12.96KW Solar with Ground Mount Rails and Wiring

12KW EMP Shield Complete Offgrid Solar Kit - 15kWh Lithium Battery + 15K Sol-Ark Inverter + 12.96KW Solar with Ground Mount Rails and Wiring

This Package is a great starter package for a Complete Offgrid Home. This Lithium Battery bank will give you 15000 Watts of usable Energy. The Solar Array will produce around 58320Watts per day based on 4.5 hours sun. This size of system generally works great for cabins, smaller - Mid sized homes, and etc that use around 1100-1700 KWH per month. This system is built to be scaled up for future additions of Panels or Batteries.

24x 540W Bifacial Mono Solar Panels (12960 Watt Array)
1x Sol-Ark Hybird/Offgrid All in ONE Inverter 15k 48V (Included MPPT Charge Controller built in)
1x 15kWh Big Battery 48V Kong Elite Lithium Battery
1x Complete Set of Iron Ridge GROUND MOUNT Rails / Top Caps / Rail Connectors / Fasteners and Bolts - Aluminum
1x Solar Combiner Box (Built for future expansion of additional panels)
1x Anderson Plug Battery Cable Set for Inverter / Battery Connection
10x 10AWG MC4 Solar Array Cabling 10' Sets (Only Used if wiring in parallel).
1x Spool 500' PV Direct Burial 10AWG Solar Wire (Solar array to Inverter wiring)
1x Spool 100' AC Output / Input / Generator Cabling - 6 AWG
__________________________________________________________________________________________________________________________
1x EMP Shield Protection Package - DC & AC Inputs/Outputs

EMP Protection - All Phases of EMP (E1, E2, & E3)
Lightning Protection
Solar Flare (Coronal Mass Ejection) Protection - Up to 228,000 Amps

EMP Shield is a family of incredibly robust EMP, solar flare, and lightning defense technologies.
They have been designed to exceed the US Military requirements for protection against a high-altitude nuclear detonation that results in an electromagnetic pulse. This family of products has been tested at Keystone Compliance, a DOD Certified Testing Laboratory, to verify compliance with the following Military Standards:

MIL-STD-461-RS105 Transient electromagnetic pulse of up to 50 kV/m, double exponential wave with a rise time in the nanosecond range, that is applied to the equipment under test (EUT) at least 5 times. We tested at 50 kV/m and also 90 kV/m (80% above required testing voltage).

MIL-STD-188-125-1 High Altitude EMP

MIL-STD-461G Control of Electromagnetic Interference

MIL-STD-461-CS-115 The purpose of CS115 is to test an electronic or electrical system to withstand signals coupled onto the test unit's associated cabling. The test unit will be subjected to rise and fall times, pulse width, and amplitude as specified on Figure CS115-1 at a 30 Hz rate for one minute;

MIL-STD-461-CS116 applies to 10 kHz to 100 MHz for all interconnecting cables, including power cables, and individual high side power leads;

MIL-STD-461 CS117 apples to all safety-critical equipment interconnecting cables and non-safety critical equipment with interconnecting cables/electrical interfaces that are part of or connected to equipment performing safety critical functions. The goal is to test the unit's ability to withstand lightning transients coupled onto the test unit's associated cables and power leads;

MIL-STD-464C Electromagnetic Environmental Effects Requirements for Systems.

__________________________________________________________________________________________________________________________

These Solar Panels are BiFacial with Double Glass. Bifacial technology enables additional energy harvesting from rear of panel (up to 25% more). These will produce more power output in weak light conditions, such as cloudy, hazy or early morning conditions. These panels offer High Wind and snow resistance loads as well. 5400 PA Snow Load / 2400 PA Wind Load. They have a 30 Year Power Warranty

Ground Mount System built based on 2" Pipe setup. Customer will source 2" sch 40 Pipe Locally, we supply everything else


1x Installation Manual

Sol-Ark 15K Inverter Specs
Output - 120/240 Split Phase
Can be used With or Without Batteries
48V Battery Backup Input (Flood Lead Acid Or Lithium)
Grid Tie Or Offgrid
Built in MPPT Charge Controller - 3x MPPT Inputs
Generator Support
LCD Touch Screen
WIFI Connectivity
DC Transformerless
Inverter Efficiency 97.5%
NEMA 3R Rated - (Outdoor use approved)
10 Year Warranty

Parallel Stacking up to 8 units
4MS Transfer time from Batteries to Grid Power